|
Test and Measuring Instruments
OMEGA TYPE CTS - 101
Semiconductor component checker & curve tracer are useful for
checking & tracing the characteristics curve of a variety of
components in a very short time duration. The Instrument consist of
five different sections, detail Specifications & features are
following: -
SECTION - 1. DIODE CHECKER :-
SPECIFICATIONS:
- Indicates whether diode is open circuit, short circuit & if working, its polarity.
- Silicon & germanium, both types of diodes can be tested.
FEATURES:
Two LED's & One test switch are provided showing:
- Open diode - If both LED's are OFF.
- Short diode - If both LED's are ON.
- Good diode - If one glows fully & other dim.
SECTION - 2. TRANSISTOR CHECKER:
SPECIFICATIONS:
- For good transistor LED marked GOOD will glow.
- For bad transistor LED marked BAD will glow..
FEATURES:
- One transistor socket and three sockets are provided.
- A switch decides NPN or PNP transistor.
- Good transistor - If one glows fully & other dim.
SECTION-3 FETCHECKER:
SPECIFICATIONS:
- For GOOD FET, the meter needle vibrates continuously between a maximum position to a minimum position.
- For BAD FET, either there is no response in the meter or it holds at one point.
FEATURES:
- One transistor socket and three sockets are provided
- An ammeter off marange is provided
- Designed to test almost all FET's.
SECTION-4. TRANSISTOR PARAMETER CHECKER:
SPECIFICATIONS
TRANSISTOR TESTER TESTSL LEAKAGE AND GAIN ATTWO RANGES LOW AND HIGH
lcbo TEST
|
0 to 15 µA on LOW range: 0 to 50µA
on HIGH range
|
LEAKAGE TEST
|
0 to 500 µA on LOW range: 0 to
1500mA on HIGH range
|
GAIN TEST
|
0 to 50µA on LOW range: 0 to 150µA
on HIGH range for values of base
current i.e. 300, 150, 50 & 25µA |
FEATURES:
- Big 115mm x 55mm (4.5" x 2.25") dial of meter increases the accuracy of readings
- Four values of base curent are provided for gain measurement so that gain can be compared under four conditions
- A six position selector switch selects gain at 300, 150, 50 and 25µA base current, leakage and L, currents
- Another switch selects HIGH and LOW ranges.
- A transsistor socket is provided for transistors with short leads, and three sockets for any other.
- A PNP - NPN Switch selects PNP or NPN transistor to be checked
SECTION - 5, CURVE TRACER: -
SPECIFICATIONS:
Semiconductor Device range
- Bipolar Transistor (NPN & PNP)
- FET (Juction N & P Type)
- SCR
- UJT (N-Channel)
- ZENER Diode (Upto 50V Vz)
- GERMANIUMA SILICON DIODES
- LED
FEATURES:
- Full protection of semi-conductor devices
- Full protection of internal circutry
- Selection of Forward or Reverse characteristics for Zener diodes, diodes and LED by a switch
- Easy of operation due to minimum number of panel settings
COMMON FEATURES
- For connecting devices two Nos. of 3 test cables are provided
- Power requirement: 230V +- 10% at 50 Hz A.C. Mains
- Strongly supported by detailed operating instractions
- Weight: 4kg (approx.)
- Dimensions: W 340 x H 110 x D 210
OTHER APPARATUS REQUIRED
|
